Wet rooms
Wet room installation in London. Level-access showers on a factory-waterproof board system.
Walk-in showers, wet rooms, steam rooms and hammams, fully tanked, with the plumbing and electrics in-house.
Level-access walk-in shower in 120 × 60 cm quartzite-effect porcelain, run continuously across walls and floor. Stretch ceiling with lighting on a battery-powered dimmer switch.
Specification
Waterproofing built into the substrate, not applied on site.
wedi board: an XPS core, waterproof through its full thickness
Sealing tape on every board joint, every washer sealed with wedi 610
Level-access shower elements with the falls factory-formed, point or linear drain
Certified wedi installer, with an extended warranty
Plumbing and electrics in-house, not subcontracted
Walk-in showers
Level-access floors with linear drains, and niches cut from the same porcelain and mitred at every return.
Walk-in shower in 120 × 60 cm limestone-effect porcelain, with ribbed wood-effect porcelain at low level and a linear drain.
Bench seat built under the window, concealed brushed brass brassware and a linear drain, in 120 × 60 cm quartzite-effect porcelain.
Shower column with rain head over a level-access floor, linear drain along the wall.
Niche cut from the same porcelain and mitred at every return, the shelf returns included.
Wall-hung WC on a concealed cistern beside the walk-in shower. Fully tanked, with underfloor heating throughout.
Steam rooms
A steam room needs a vapour barrier, not waterproofing alone: wedi Vapor board, or a bonded sheet membrane over XPS board, with epoxy grout throughout.
Steam room on wedi Vapor board: olive glass mosaic, a cylindrical mosaic basin and 600 × 1200 mm travertine-effect porcelain underfoot.
Hammam in iridescent glass mosaic on XPS board with a bonded sheet membrane. The arched panel arrived pre-assembled; the mosaic around it was cut on site.
Preparation
Before a tile goes on, every board joint is taped and every washer sealed.
One factory-made board replaces both the substrate and the tanking layer. In a wet area, board joints take sealing tape, corners take wedi internal and external corner pieces, and every washer is sealed with wedi 610. Plywood for basins and frames for wall-hung WCs go in first, with the board laid over them.
Shower area lined in wedi board: washers sealed with wedi 610, sealing tape on the board joints, internal corners fitted.
Projects
The finished rooms behind these photos.
Get in touch
Send drawings or photos of the room, rough sizes and your postcode.
By phone, on WhatsApp or through the contact form.
Supply and fix, or fix only with tiles you have already chosen.